Buggies & Buds shop hop 

Make and Take Instructions: Line up chipboard A-B-A with top and bottom even leaving a 1/4" gap between pieces. Put adhesive on both sides of C (2pcs) and center half over gap to glue your book together. Do same with 2nd C to cover other gap. Put adhesive all the way around your chipboard then attach to the large dec pc that is your cover on the inside so that your outside cover is out. Fold top down, Bottom up and the 2 sides in then open back up and cut all 4 corners diagonal across stayin about 1/4" from chipboard then apply adhesive to all 4 edges of paper and fold back down onto your chipboard inside. Spine: This pc is scored. Starting with largest pc skip that and the next 1/2" section then fold the next 2 1/2" sections together in a mountain fold and glue together on the inside. Skip the next 1/2" section and fold the next to sections together in a mountain fold and glue together on the inside. This makes your 2 page spines. Put adhesive all around on the underside of spine pc and center on your inside of your book being sure to keep the 2 pages in the center and not over the folds in chipboard. You have 2 D pieces and 2 E pcs. On D fold the 2 scored ends under and glue the outside of those folded pieces and attach them to E. This will make your pages. Do this for both D's and E's making 2 pages. Cut a small angle off the edges of your 2 pcs sticking up on spine on both ends just slightly then apply adhesive to both sides of them and slide the open end of your page down over the spine to make your page. The last 2 black page pieces will cover the 2 ends on inside of book. Decorate the pages and inside with the remaining decorative pieces.

Enjoy!